Two sealed bearings mounted side-on to the blade, control blade twist and keep it true. The rear bearing takes the thrust of the back of the blade allowing it to run freely. The same setup is then repeated beneath the table.
The cast iron table tilts from 90 degrees to 45 degrees, on a rack & pinion, and has a positive stop at both of those positions. Any angle in between can be read off the scale and locked in. For rip cuts the guide fence can be situated on either side of the blade, can be locked into position with a single press of the lever and has a clear marker to set against the metric scale. The fence itself can be fitted in two ways. When cutting thicker material the full face height of 60mm is used.
When cutting thin and narrow strips the fence is fitted with the small face, against the blade to allow clearance around the guides. The bandsaw is fitted with an LED work light on a flexible stem, so that the work area will always be well lit. The two doors are fitted with safety locks which cut power to the motor when the doors are open for blade changing or cleaning. Tensioning the blade correctly is made simple thanks to the features on this premium model. A blade tension lever quickly sets the tension.After a blade change fine tuning can be carried out with the aid of a tension indicator and scale. The required tension varies according to blade width. A window in the top door allows the operator to confirm blade tension is correct and make an adjustment when necessary. A dust extractor is always recommended when using a bandsaw. The dust collection outlet has 3 rings which allow it to accept 3 sizes of hose, 50mm, 75mm & 100mm diameter making it compatible with any type of extraction system.
If extraction is not being used however, the bandsaw is fitted with an integral dust collection draw. Dust falling into the base of the machine will be collected here, allowing it to be quickly and easily emptied. Supplied with rip fence, mitre fence, work light, floorstand, cable and plug. Precision ground cast iron work table.
Quick action locking on rip fence. Mains powered LED work light.
Maximum cutting depth - 230mm (9). Throat width - 345mm (14).
Table size - 545mm x 515mm. Table tilt - 0-45 degrees. Cutting speed - 800 and 370m/min.Motor (induction) 1100W (1.1/2hp) 230v. Blade widths - 6-25mm (1/4" - 1"). Dimensions (WxDxH) - 900mm x 720mm x 1720mm. AB, BT, FK, GY, HS, IM, IV, KA, KW, PA, PH, ZE, all Islands. This item is in the category "Home, Furniture & DIY\DIY Tools & Workshop Equipment\Power Tools\Power Saws\Band Saws".
The seller is "everydaysavings_1" and is located in this country: GB. This item can be shipped to United Kingdom.